![]() ![]() Click on OK, and the beeping should stop. Make sure after you move all the sticks and click done, you put them all, including the throttle, in the center. Make sure you do the radio setup from the screen that looks like this: If you haven't set up the radio you get this: It applies to the overall, or automatic ESC calibration with the APM (the part with the battery plug/unplug and moving lights on APM) It also applies to the radio calibration in the mission planner. It applies to the ESCs so that they each individually know what is maximum and minimum (the manual part, connected to throttle on the receiver). This happens on all my planes so it’s not an esc calibration issue. in general to calibrate esc you need to put full throtel then plug your esc and put down you throtel. Check the documentation for the ESC you have or the firmware you installed. See attached pics showing no throttle input (-100) and when the motor start running (-72). Calibrating the ESC is something that depends on the firmware. ![]() When I push the throttle stick the prop or Edf will not start running until I’m almost 30 clicks in. The APM needs to know what all the minimum, maximum and center values are that your controller is sending so that it knows what you're telling it.Ĭalibration is a word that gets used a lot, and it applies to two things. Hi guys, I’m having an issue with the throttle on my d圆e. When you set up a new copter, or install new firmware, it knows if the radio transmitter (the remote) is set up or not. I read this little forum thread and there's one thing that may have been missed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |